There are 120V to 220/230 voltage converters. The simplest is a 1:2 transformer. Alternative are modern electronic converters. Check how many ampere or VA your equipment uses. It should be on a label next to the voltage. Then chose a transformer or converter which preferable a bit more ampere or VA then that. Unscrew the faceplate and disconnect the cables from the terminals of the single socket mounting box. Next, run green/yellow sleeving over the earth core if you find it bare. Remove the knockout in the new surface mounting box and pass the cables through it. Using a pencil, mark the fixing holes on the wall. BTW - Most Grizzly 230 Volt machines are wired for three phase. When only single phase power is used, two of the legs of the switch are used. To convert a machine to three phase, the motor is replaced with a three phase model and wired to the switch. The power chord is also replaced with a 3 phase power chord. This two-wire plug is ungrounded, unpolarised and has two round prongs. It is popularly known as the Europlug which is described in CEE 7/16. The plug has two 4 mm round pins, measuring 19 mm in length on centres spaced 18.6 mm apart at the base and 17.5 mm apart at the tip. The two pins have 10 mm long insulated sleeves. 230V Industrial Mains Plugs & Sockets. Find a huge range of 230V Industrial Mains Plugs & Sockets at Farnell. We stock a wide range of Industrial Mains Plugs & Sockets, such as 415V , 250V , 230V , 400V Industrial Mains Plugs & Sockets from the worlds top manufacturers: MULTICOMP PRO, WALTHER, PCE, PRO ELEC, ILME & more. To meet Australia power voltage requirements, single phase electricity is usually connected at 230 volts (240 volts is still used in Western Australia and Queensland, although the latter has started the transition to 230V). Any single phase machine up to a 10 amp current will usually (not always) have a standard three-pin plug fitted. Server /IT Rack mount power distribution unit, 1Ph, 230V, 16A, 50/60Hz, 2U standard with 6 X Indian Round Pin/ Octogonal, 5/15A, Inlet Plug type 16A Indian Round Pin 16A MCB - PDU Rating 3.6KVA/Rear feed-1.5Mt/ Black. PDU-H-1-IND-C6-X3-Y1-Z0. Indian Sockets Single Phase. In the Single Phase system, the voltage level between Phase and Neutral is 230V. In Three Phase System, the voltage level between any two phases out of three phases is 400V, Not 415, 440, 660 or 690V. This is only possible in case of ±% variation e.g. 400V±10% = 400V + 40V = 440V. That is the case for Voltage only. 230V -6% +10% (i.e. 216.2 V – 253.0 V) This effectively means there is no real change of supply voltage, only a change in the “label”, with no incentive for electricity supply companies to actually change the supply voltage. To cope with both sets of limits all modern equipment will therefore be able to accept 230V +/-10% i.e. 207-253V. 4BfInxI.

is 230v a normal plug